H3C S3600 Series

Operation Manual – Multicast
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 7 PIM Configuration
7-22
Host A is the receiver of the multicast group whose multicast IP address is 225.0.0.1.
Host B begins to send data to the destination 225.0.0.1 and LS_A receives the
multicast data from Host B through LS_B.
II. Network diagram
Figure 7-8 Network diagram for PIM-SM configuration
III. Configuration procedure
1) Configure LS_A.
# Enable PIM-SM.
<H3C> system-view
[H3C] multicast routing-enable
[H3C] vlan 10
[H3C-vlan10] port Ethernet 1/0/2 to Ethernet 1/0/3
[H3C-vlan10] quit
[H3C] interface Vlan-interface 10
[H3C-Vlan-interface10] pim sm
[H3C-Vlan-interface10] quit
[H3C] vlan 11
[H3C-vlan11] port Ethernet 1/0/4 to Ethernet 1/0/5
[H3C-vlan11] quit