To Next Page

To Previous Page

Operation Manual – Multicast

H3C S3600 Series Ethernet Switches-Release 1510 Chapter 2 IGMP Snooping Configuration

2-15

<H3C> system-view

[H3C] igmp-snooping enable

# Enable IGMP Snooping on VLAN 10 where no Layer 3 multicast protocol is enabled.

[H3C] vlan 10

[H3C-vlan10] igmp-snooping enable

2.4.2 Example 2

Configure multicast VLAN on Layer 2 and Layer 3 switches.

I. Network requirements

The multicast source is Workstation. Switch A forwards the multicast data flows that the

multicast source sends. The multicast data flows are forwarded by the Layer 2 switch

Switch B to the end user PC1 and PC2.

Table 2-15 describes the network devices involved in this example and the

configurations you should make on them.

Table 2-15 Network devices and their configurations

Device Description

Switch A Layer 3 switch

The interface IP address of VLAN 20 is 168.10.1.1.

Ethernet1/0/1 is connected to the workstation and

belongs to VLAN 20.

VLAN 10 is the multicast VLAN.

Ethernet1/0/5 belongs to VLAN 2, Ethernet1/0/6

belongs to VLAN 3, and Ethernet1/0/10 is

connected to Switch B.

Switch B Layer 2 switch

VLAN 2 contains Ethernet1/0/1 and VLAN 3

contains Ethernet1/0/2. The two ports are

connected to PC1 and PC2, respectively.

Ethernet1/0/10 is connected to Switch A.

PC 1 User 1 PC1 is connected to Ethernet1/0/1 on Switch B.

PC 2 User 2 PC2 is connected to Ethernet1/0/2 on Switch B.

Configure a multicast VLAN, so that the users in VLAN 2 and VLAN 3 can receive

multicast streams through the multicast VLAN.

H3C S3600 Series User Manual

Other manuals for H3C S3600 Series