Operation Manual – File System Management
H3C S3600 Series Ethernet Switches-Release 1510
Chapter 1 File System Management
Configuration
1-3
Caution:
z Before configuring the main or backup attribute for a file in the fabric, make sure the
file already exists on all devices in the fabric.
z The configuration of the main or backup attribute of a Web file takes effect
immediately without restarting the switch.
z After upgrading a Web file, you need to specify the new Web file in the Boot menu
after restarting the switch. Otherwise, the Web server cannot function normally.
z Currently, a configuration file has the extension of cfg and resides in the root
directory of the Flash memory.
1.2 File System Configuration
1.2.1 Introduction to File System
To facilitate management on the Flash memory, Ethernet switches provide the file
system module. The file system allows users to create/delete a directory, display the
current work directory, display the contents of a directory, and access files.
By default, a switch prompts for confirmation before executing the commands which
have potential risks (for example, deleting and overwriting files).
1.2.2 Introduction to Configuration Tasks on the File System
Table 1-3 Configuration tasks on the file system
Configuration task Description Related section
Directory operation Optional Section 1.2.3 “Directory Operations”
File operation Optional Section 1.2.4 “File Operations”
Flash memory
operation
Optional Section
1.2.5 “Flash Memory Operations”
Prompt mode
configuration
Optional Section
1.2.6 “Prompt Mode Configuration”
To Next Page
Loading...
Need help?
General