Operation Manual – ACL
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1
ACL Configuration
1-3
1.1.3 Time Range-based ACL
A time range-based ACL takes effect only in specified time ranges.
You can specify a time range for each rule in an ACL. An ACL rule cannot take effect if
you do not configure the time range for it. It takes effect only when the time range is
configured and the system time is within the time range. If you remove the time range of
an ACL rule, the ACL rule becomes invalid after the ACL rule timer refreshes.
1.1.4 Types of ACLs Supported by the Ethernet Switch
The following types of ACLs are supported by the Ethernet switch:
z Basic ACL
z Advanced ACL
z Layer 2 ACL
z User-defined ACL
1.2 Time Range Configuration
A time section can be periodic or absolute. A periodic time section is defined by
specifying days of a week, while an absolute time section is defined by specifying the
start time and the end time.
Note:
An absolute time range on an H3C S3600 switch can be within the range 1970/1/1
00:00 to 2100/12/31 24:00.
1.2.1 Configuration Procedure
Table 1-1 Configure a time range
Operation Command Description
Enter system view
system-view
—
Create a time
range
time-range time-name { start-time to
end-time days-of-the-week [ from start-time
start-date ] [ to end-time end-date ] | from
start-time start-date [ to end-time end-date ] |
to end-time end-date }
Required
Note that:
To Next Page
Loading...
Need help?
General