H3C S3600 Series User Manual

Operation Manual – SNMP-RMON
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1
SNMP Configuration
1-3
Table 1-1 Common MIBs
MIB attribute MIB content Related RFC
MIB II based on TCP/IP
network device
RFC1213
RFC1493
BRIDGE MIB
RFC2675
RIP MIB RFC1724
RMON MIB RFC2819
Ethernet MIB RFC2665
OSPF MIB RFC1253
Public MIB
IF MIB RFC1573
Private MIB
DHCP MIB
QACL MIB
ADBM MIB
RSTP MIB
VLAN MIB
Device management
Interface management
—
1.2 Configuring Basic SNMP Functions
SNMPv3 configuration is quite different from that of SNMPv1 and SNMPv2C. Therefore,
the configuration of basic SNMP functions is described by SNMP versions, as listed in
Table 1-2 and Table 1-3.
Table 1-2 Configure basic SNMP functions (SNMPv1 and SNMPv2C)
Operation Command Description
Enter system view
system-view
—
Enable SNMP agent
snmp-agent
Optional
By default, SNMP
agent is disabled.
You can enable
SNMP agent by
executing this
command or any of
the commands used
to configure SNMP
agent.

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English