H3C S3600 Series

Operation Manual – SNMP-RMON
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1
SNMP Configuration
1-5
Table 1-3 Configure basic SNMP functions (SNMP V3)
Operation Command Description
Enter system
view
system-view
—
Enable SNMP
agent
snmp-agent
Required
By default, SNMP Agent
is disabled.
You can enable SNMP
agent by executing this
command or any of the
commands used to
configure SNMP agent.
Set system
information
snmp-agent sys-info { contact
sys-contact | location sys-location |
version { { v1 | v2c | v3 }* | all } }
Optional
By default, the contact
information for system
maintenance is "R&D
Hangzhou, H3C
Technologies Co.,Ltd.",
the system location is
"Hangzhou China", and
the SNMP version is
SNMPv3.
Set an SNMP
group
snmp-agent group v3 group-name
[ authentication | privacy ]
[ read-view read-view ] [ write-view
write-view ] [ notify-view
notify-view ] [ acl acl-number ]
Required
Add a user to
an SNMP group
snmp-agent usm-user v3
user-name group-name
[ authentication-mode { md5 |
sha } auth-password
[ privacy-mode des56
priv-password ] ] [ acl acl-number ]
Required
Set the
maximum
SNMP packet
size for SNMP
agent
snmp-agent packet max-size
byte-count
Optional
By default, the maximum
SNMP packet size is
1,500 bytes.
Set the device
engine ID
snmp-agent local-engineid
engineid
Optional
By default, the device
engine ID is formed by
appending device
information to the
enterprise number.