H3C S3600 Series User Manual

Operation Manual – Cluster
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1
Cluste
r
1-10
1.2.7 Configuring Cluster Parameters
I. Manually building a cluster and configuring cluster parameters
Table 1-8 Manually build a cluster and configure cluster parameters
Operation Command Description
Enter system view
system-view
—
Specify the
management
VLAN
management-vlan vlan-id
Required
By default, VLAN 1 is used as
the management VLAN.
Enter cluster view
cluster
—
Configure a IP
address pool for
the cluster
ip-pool
administrator-ip-address
{ ip-mask | ip-mask-length }
Required
Build a cluster
build name
Required
name: cluster name.
Configure a
multicast MAC
address for the
cluster
cluster-mac H-H-H
Optional
By default, the cluster
multicast MAC address is
0180-C200-000A.
Set the interval for
the management
device to send
multicast packets
cluster-mac syn-interval
time-interval
Optional
By default, the interval to send
multicast packets is one
minutes.
Set the holdtime of
member switches
holdtime seconds
Optional
By default, the holdtime is 60
seconds.
Set the interval to
send handshake
packets
timer interval
Optional
By default, the interval to send
handshake packets is 10
seconds.
Quit cluster view
quit
—
II. Starting automatic cluster building
Table 1-9 Start automatic cluster building
Operation Command Description
Enter system view
system-view
—
Enter cluster view
cluster
—

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English