H3C S3600 Series User Manual

Operation Manual – MAC Address Table
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1 MAC Address Table Management
1-6
can dynamically maintain. When the number of the MAC address entries learnt from a
port reaches the set value, the port stops learning MAC addresses.
Table 1-5 Set the maximum number of MAC addresses a port can learn
Operation Command Description
Enter system view
system-view
—
Enter Ethernet port
view
interface interface-type
interface-number
—
Set the maximum
number of MAC
addresses the port
can learn
mac-address
max-mac-count count
Required
By default, the number of the
MAC addresses a port can
learn is not limited.
1.3 Displaying and Maintaining MAC Address Table
Configuration
To verify your configuration, you can display information about the MAC address table
by executing the display command in any view.
Table 1-6 Display and maintain MAC address table configuration
Operation Command Description
Display information about
the MAC address table
display mac-address
[ display-option ]
Display the aging time of
the dynamic MAC address
entries in the MAC address
table
display mac-address
aging-time
The display command
can be executed in any
view.
1.4 Configuration Example
I. Network requirements
z Log in to the switch through the Console port and enable address table
configuration.
z Set the aging time of dynamic MAC address entries to 500 seconds.
z Add a static MAC address entry 000f-e235-dc71 for Ethernet1/0/2 port (assuming
that the port belongs to VLAN 1)

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English