H3C S3600 Series User Manual

Operation Manual – Cluster
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1
Cluste
r
1-16
Table 1-18 Display and maintain cluster configuration
Operation Command Description
Display all NDP
configuration and running
information (including the
interval to send NDP
packets, the holdtime, and
all neighbors discovered)
display ndp
Display NDP configuration
and running information on
specified ports (including
the neighbors discovered by
NDP on the ports)
display ndp interface
port-list
Display global NTDP
information
display ntdp
Display device information
collected by NTDP
display ntdp device-list
[ verbose ]
Display status and statistics
information about the cluster
display cluster
Display information about
the candidate devices of the
cluster
display cluster
candidates
[ mac-address H-H-H |
verbose ]
Display information about
the member devices of the
cluster
display cluster members
[ member-number |
verbose ]
You can execute the
display command in
any view.
Clear NDP statistics on
ports
reset ndp statistics
[ interface port-list ]
You can execute the
reset command in user
view.
1.6 Cluster Configuration Example
1.6.1 Basic Cluster Configuration Example
I. Network requirements
Three switches compose a cluster, where:
z An S3600 series switch serves as the management device.
z The rest are member devices.
Serving as the management device, the S3600 switch manages the two member
devices. The configuration for the cluster is as follows:
z The two member devices connect to the management device through
Ethernet1/0/2 and Ethernet1/0/3.
z The management device connects to the Internet through Ethernet1/0/1.

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English