H3C S3600 Series User Manual

Operation Manual – Routing Protocol
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 2
Static Route Configuration
2-5
# Configure the default gateway of Host B to 1.1.4.1. Detailed configuration procedure
is omitted.
# Configure the default gateway of Host C to 1.1.1.1. Detailed configuration procedure
is omitted.
Now, all the hosts/switches in the figure can interconnect with each other.
2.5 Troubleshooting a Static Route
Symptom: The switch is not configured with a dynamic routing protocol. Both the
physical status and the link layer protocol status of an interface are UP, but IP packets
cannot be normally forwarded on the interface.
Solution: Perform the following procedure.
Use the display ip routing-table protocol static command to view whether the
corresponding static route is correctly configured.
Use the display ip routing-table command to view whether the static route is valid.

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English