To Next Page

To Previous Page

Operation Manual – SSH Terminal Service

H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1

SSH Terminal Service

1-19

Figure 1-11 SSH client interface

2) Enter the username and password to establish an SSH connection.

3) To log out, enter the quit command.

1.1.4 Configuring the Device as an SSH Client

When the device connects to the SSH server as an SSH client, you can configure the

SSH client to authenticate the SSH server during the first access.

z The first authentication means that when the SSH client accesses the server for

the first time and is not configured with the server host public key, the user can

choose to continue accessing the server and save the host public key on the client

for future authentication of the server.

z With first authentication not supported, the client cannot authenticate the server if

it is not configured with the server host public key. In this case, you must configure

the host public key of the server and specify the key name on the client

beforehand, so that the client can authenticate the server.

You can configure the client to use a specified IP address or interface to access the

SSH.

H3C S3600 Series User Manual

Other manuals for H3C S3600 Series