H3C S3600 Series User Manual

Operation Manual – Multicast
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 2 IGMP Snooping Configuration
2-7
Table 2-5 Enable IGMP Snooping
Operation Command Description
Enter system view system-view —
Enable IGMP Snooping
globally
igmp-snooping enable
Required
By default, IGMP
Snooping is disabled
globally.
Enter VLAN view
vlan vlan-id
—
Enable IGMP Snooping
on the VLAN
igmp-snooping enable
Required
By default, IGMP
Snooping is disabled on
the VLAN.
Caution:
z Although both Layer 2 and Layer 3 multicast protocols can run on the same switch
simultaneously, they cannot run simultaneously on a VLAN or its corresponding
VLAN interface.
z Before configuring IGMP Snooping in VLAN view, you must enable IGMP Snooping
globally in system view. Otherwise, the IGMP Snooping feature cannot be enabled
in VLAN view.
2.2.2 Configuring Timers
This configuration task is to manually configure the aging timer of the router port, the
aging timer of the multicast member ports, and the query response timer.
z If the switch receives no general IGMP query message from a router within the
aging time of the router port, the switch removes the router port from the port
member lists of all the multicast groups.
z If the switch receives no IGMP host report message within the aging time of the
member port, it sends IGMP group-specific query to the port.
Table 2-6 Configure timers
Operation Command Description
Enter system view system-view —
Configure the aging timer
of the router port
igmp-snooping
router-aging-time
seconds
Optional
By default, the aging time
of the router port is 105
seconds.

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English