H3C S3600 Series User Manual

Operation Manual – VLAN-VPN
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1
VLAN-VPN Configuration
1-5
Operation Command Description
Enable the inner VLAN
Tag priority replication
function
vlan-vpn inner-cos-trust
enable
Required
By default, the inner
VLAN tag priority
replication function is
disabled. And the priority
of an outer VLAN tag is
that of the default priority
of the current port.
Display the VLAN-VPN
configuration of about all
ports
display port vlan-vpn
This command can be
executed in any view.
Caution:
If you have configured the port priority, (refer to the QoS&QoS Profile part of H3C
S3600 Series Ethernet Switches Operation Manual for more), after you configure to
replicate the tag priority of the inner VLAN tag of a VLAN-VPN packet, the switch will
prompt that the port priority configuration on the current port is invalid.
1.4 TPID Adjusting Configuration
1.4.1 Configuration Prerequisites
The TPID value of the peer end of the public network is available.
1.4.2 Configuration Procedure
Table 1-4 Adjust TPID values for VLAN-VPN packets
Operation Command Description
Enter system view
system-view
—
Enter Ethernet port view
interface interface-type
interface-number
—
Set a TPID value for the
port
vlan-vpn tpid value
Required
Do not set the TPID value
to any of the protocol type
values listed in
Table 1-1.
Display VLAN-VPN
configuration information
about all ports
display port vlan-vpn
You can execute the
display command in any
view.

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English