H3C S3600 Series

Operation Manual – Multicast
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 8 MSDP Configuration
8-20
III. Solution
1) Check the connectivity of the route between the routers. Use the display ip
routing-table command to check that the unicast route between the routers is
correct.
2) Further check that a unicast route exists between two routers that will become
MSDP peers and that the route leads to the two peers.
3) Verify the configuration of the import-source command and the corresponding
ACL to ensure that the ACL rule filters the right (S, G) entries.