To Next Page

To Previous Page

Operation Manual – FTP and TFTP

H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1

FTP and TFTP Configuration

1-18

III. Configuration procedure

1) Start the TFTP server and configure the work directory on the PC.

2) Configure the switch.

# Log into the switch. (You can log into a switch through the Console port or by

Telneting to the switch. See the “Login” module for detailed information.)

<H3C>

Caution:

If available space on the Flash memory of the switch is not enough to hold the file to be

uploaded, you need to delete files from the Flash memory to make room for the file.

# Enter system view

<H3C> system-view

[H3C]

# Configure the IP address of a VLAN interface on the switch to be 1.1.1.1, and ensure

that the port through which the switch connects with the PC belongs to this VLAN. (This

example assumes that the port belongs to VLAN 1.)

[H3C] interface Vlan-interface 1

[H3C-Vlan-interface1] ip address 1.1.1.1 255.255.255.0

[H3C-Vlan-interface1] quit

# Download the switch application named switch.bin from the TFTP server to the

switch.

<H3C> tftp 1.1.1.2 get switch.bin switch.bin

# Upload the switch configuration file named config.cfg to the TFTP server.

<H3C> tftp 1.1.1.2 put config.cfg config.cfg

# Use the boot boot-loader command to specify the downloaded file (switch.bin) to be

the startup file used when the switch starts the next time, and restart the switch. Thus

the switch application is upgraded.

<H3C> boot boot-loader switch.bin

<H3C> reboot

H3C S3600 Series User Manual

Other manuals for H3C S3600 Series