H3C S3600 Series

Operation Manual – Routing Protocol
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 3
RIP Configuration
3-8
Table 3-7 Disable the receiving of host route
Operation Command Description
Enter system view
system-view
—
Enter RIP view
rip
—
Disable the receiving of
host routes
undo host-route
Optional
By default, the router
receives host routes.
IV. Configuring RIP to filter incoming/outgoing routes
The route filtering function provided by a router enables you to configure
inbound/outbound filter policy by specifying an ACL or address prefix list to make RIP
filter incoming/outgoing routes. Besides, you can configure RIP to receive only the
RIP packets from a specific neighbor.
Table 3-8 Configure RIP to filter incoming/outgoing routes
Operation Command Description
Enter system view
system-view
—
Enter RIP view
rip
—
filter-policy { acl-number |
ip-prefix ip-prefix-name
[ gateway ip-prefix-name ] |
route-policy
route-policy-name } import
Configure RIP to filter
incoming routes
filter-policy gateway
ip-prefix-name import
Required
By default, RIP does
not filter any incoming
route.
The gateway keyword
is used to filter the
incoming routes
advertised from a
specified address.
filter-policy { acl-number |
ip-prefix ip-prefix-name }
export [ routing-protocol ]
Configure RIP to filter
outgoing routes
filter-policy route-policy
route-policy-name export
Required
By default, RIP does
not filter any outgoing
route.