To Next Page

To Previous Page

Operation Manual – VLAN-VPN

H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1

VLAN-VPN Configuration

1-3

Protocol type Value

IS-IS 0x8000

LACP 0x8809

802.1x 0x888E

1.2 VLAN-VPN Configuration

1.2.1 Configuration Prerequisites

z GARP VLAN registration protocol (GVRP), GARP multicast registration protocol

(GMRP), intelligent resilient framework (IRF), neighbor topology discovery

protocol (NTDP), spanning tree protocol (STP), 802.1x and centralized MAC

address authentication function are disabled on the port.

z The port is an access port.

Caution:

z The VLAN-VPN function is unavailable to a port if any of the protocols among GVRP,

GMRP, IRF, NTDP, STP, 802.1x and centralized MAC address authentication

function is enabled on the port.

z By default, STP and NTDP are enabled on a device. You can disable these two

protocols using the stp disable and undo ntdp enable commands.

z The VLAN-VPN function is unavailable to all the ports of a device if the fabric

function is enabled on a port of the device.

1.2.2 Configuration Procedure

Table 1-2 Configure the VLAN-VPN function for a port

Operation Command Description

Enter system view

system-view

—

Enter Ethernet port view

interface interface-type

interface-number

—

Enable the VLAN-VPN

function on the port

vlan-vpn enable

Required

By default, the

VLAN-VPN function is

disabled on a port.

H3C S3600 Series User Manual

Other manuals for H3C S3600 Series