H3C S3600 Series

Operation Manual – NTP
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1
NTP Configuration
1-17
 Note:
This example assumes that H3C3 is a switch that supports the local clock being the
master clock.
II. Network diagram
H3C 3
3.0.1.31/24
3.0.1.32/24
rface 2
rface 2
S3600-2 H3C 4
1.0.1.31/24
Vlan-inte
Vlan-inte
-interface 2
S3600-1
Vlan
H3C 3
3.0.1.31/24
3.0.1.32/24
rface 2
rface 2
S3600-2 H3C 4
1.0.1.31/24
Vlan-inte
Vlan-inte
-interface 2
S3600-1
Vlan
Figure 1-8 Network diagram for the NTP broadcast mode configuration
III. Configuration procedure
1) Configure H3C3.
# Enter system view.
<H3C3> system-view
[H3C3]
# Enter Vlan-interface2 view.
[H3C3] interface Vlan-interface 2
[H3C3-Vlan-interface2]
# Set H3C3 to the broadcast server, which sends broadcast packets through
Vlan-interface2.
[H3C3-Vlan-interface2] ntp-service broadcast-server
2) Configure S3600-1.
# Enter system view.
<S3600-1> system-view
[S3600-1]
# Enter Vlan-interface2 view.
[S3600-1] interface Vlan-interface 2
[S3600-1-Vlan-interface2]
# Set S3600-1 to a broadcast client.
[S3600-1-Vlan-interface2] ntp-service broadcast-client