H3C S3600 Series User Manual

Operation Manual – DHCP
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 2
DHCP Server Configuration
2-14
Configuration task Description Related section
Configure to bind
IP address
tically to
P clients
sta
DHC
Configure to
assign IP
addresses of
DHCP interface
address pool to
DHCP clients
Configure to
assign IP
addresses
dynamically
You must
choose at
least one of
the two
options. And
these two
options can be
configured at
the same
time.
2.3.4 "Configuring the
Mode to Assign IP
Addresses to DHCP
Clients
”
Configure DNS service for the DHCP
server
Optional
2.3.5 “Configuring DNS
Services for the DHCP
Server
”
Configure NetBIOS service for the
DHCP server
Optional
2.3.6 “Configuring DHCP
Servers
”
Customize DHCP service Optional
2.3.7 “Customizing DHCP
Service
”
Configure the connection between
the DHCP interface address pool
and the BIMS server
Optional
2.3.8 "Configuring
Connection Between the
DHCP Interface Address
Pool and the BIMS Server
”
2.3.2 Enabling DHCP
You need to enable DHCP before performing DHCP configurations. DHCP-related
configurations are valid only when DHCP is enabled.
Table 2-12 Enable DHCP
Operation Command Description
Enter system view
system-view
—
Enable DHCP
dhcp enable
Required
By default, DHCP is enabled
2.3.3 Configuring to Assign the IP Addresses of Interface Address Pools to
DHCP Clients
If the DHCP server works in the interface address pool mode, it picks IP addresses
from the interface address pools and assigns them to the DHCP clients. If there is no
available IP address in the interface address pools, the DHCP server picks IP
addresses from its global address pool that contains the interface address pool
segment and assigns them to the DHCP clients.

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English