H3C S3600 Series

Operation Manual – Multicast
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 7 PIM Configuration
7-14
Table 7-7 Configuration tasks
Operation Description Section
Configure filtering policies
for multicast
sources/groups
Optional
Section
7.4.1 "Configuring Filtering
Policies for Multicast Source/Group"
Configure BSR/RP Optional Section 7.4.2 "Configuring BSR/RP"
Configure PIM-SM
domain boundary
Optional
Section 7.4.3 "Configuring PIM-SM
Domain Boundary"
Filter the registration
packets from RP to DR
Optional
Section 7.4.4 "Filtering the
Registration Packets from RP to DR"
7.4.1 Configuring Filtering Policies for Multicast Source/Group
For the configuration of filtering policies for multicast source/group, refer to section
7.3.1 "Configuring Filtering Policies for Multicast Source/Group".
7.4.2 Configuring BSR/RP
Table 7-8 Configure BSR/RP
Operation Command Description
Enter system view system-view —
Enable the multicast
routing protocol
multicast
routing-enable
Required
Enter PIM view
pim —
Configure candidate
BSRs
c-bsr interface-type
interface-number
hash-mask-len [ priority ]
Optional
By default, candidate
BSRs are not set for the
switch and the value of
priority is 0.
Configure candidate RPs
c-rp interface-type
interface-number
[ group-policy
acl-number | priority
priority ]*
Optional
z You can configure to
filter the IP addresses
of some multicast
groups in ACL.
z By default, candidate
RPs are not set for the
switch and the value of
priority is 0.