H3C S3600 Series User Manual

Operation Manual – 802.1x
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1
802.1x Configuration
1-18
 Note:
As for the dot1x version-user command, if you execute it in system view without
specifying the interface-list argument, the command applies to all ports. You can also
execute this command in port view. In this case, this command applies to the current
port only and the interface-list argument is not needed.
1.5.4 Enabling DHCP-triggered Authentication
After performing the following configuration, 802.1X allows running DHCP on access
users, and users are authenticated when they apply for dynamic IP addresses through
DHCP.
Table 1-5 Enable DHCP-triggered authentication
Operation Command Description
Enter system view
system-view
—
Enable
DHCP-triggered
authentication
dot1x dhcp-launch
Optional
By default, DHCP-triggered
authentication is disabled.
1.5.5 Configuring Guest VLAN
Table 1-6 Configure Guest VLAN
Operation Command Description
Enter system view
system-view
—
Configure port
access method
dot1x port-method
portbased
Required
The default port access method is
MAC-address-based. That is, the
macbased keyword is used by
default.
Enable the Guest
VLAN function
dot1x guest-vlan
vlan-id [ interface
interface-list ]
Required
By default, the Guest VLAN
function is disabled.

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English