H3C S3600 Series User Manual

Operation Manual – Login
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 8
User Control
8-2
Table 8-2 Control Telnet users by source IP addresses
Operation Command Description
Enter system view
system-view
—
Create a basic ACL
or enter basic ACL
view
acl number acl-number
[ match-order { config |
auto } ]
As for the acl number
command, the config
keyword is specified by
default.
Define rules for the
ACL
rule [ rule-id ] { permit |
deny } [ fragment | source
{ sour-addr sour-wildcard |
any } | time-range
time-name ]*
Required
Quit to system
view
quit
—
Enter user
interface view
user-interface [ type ]
first-number [ last-number ]
—
Apply the ACL to
control Telnet
users by source IP
addresses
acl acl-number { inbound |
outbound }
Required
The inbound keyword
specifies to filter the users
trying to Telnet to the current
switch.
The outbound keyword
specifies to filter users trying
to Telnet to other switches
from the current switch.
8.2.3 Controlling Telnet Users by Source and Destination IP Addresses
Controlling Telnet users by source and destination IP addresses is achieved by
applying advanced ACLs, which are numbered from 3000 to 3999. Refer to the ACL
module for information about defining an ACL.
Table 8-3 Control Telnet users by source and destination IP addresses
Operation Command Description
Enter system view
system-view
—
Create an
advanced ACL or
enter advanced
ACL view
acl number acl-number
[ match-order { config |
auto } ]
As for the acl number
command, the config
keyword is specified by
default.

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English