H3C S3600 Series User Manual

Operation Manual – Information Center
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1
Information Cente
r
1-13
1.3 Displaying and Debugging Information Center
After the above configurations, you can execute the display command in any view to
display the running status of the information center, and thus validating your
configurations. You can also execute the reset command in user view to clear the
information in the log buffer and trap buffer.
Table 1-13 Display and debug information center
Operation Command Description
Display information on
an information channel
display channel [ channel-number |
channel-name ]
Display the operation
status of information
center, the
configuration of
information channels,
the format of time
stamp and the
information output in
case of fabric
display info-center [ unit unit-id ]
Display the status of
log buffer and the
information recorded in
log buffer
display logbuffer [ unit unit-id ]
[ level severity | size buffersize ]* [ |
{ begin | exclude | include }
regular-expression ]
Display the summary
information recorded in
log buffer
display logbuffer summary [ level
severity ]
Display the status of
trap buffer and the
information recorded in
trap buffer
display trapbuffer [ unit unit-id ]
[ size buffersize ]
The display
command can be
executed in any
view
Clear information
recorded in log buffer
reset logbuffer [ unit unit-id ]
Clear information
recorded in trap buffer
reset trapbuffer [ unit unit-id ]
The reset
command can be
executed in user
view
1.4 Information Center Configuration Examples
1.4.1 Log Output to a UNIX Log Host
I. Network requirements
The switch sends the following log information in English to the UNIX log host whose IP
address is 202.38.1.10: the log information of the two modules ARP and IP, with
severity higher than “informational”.

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English