Operation Manual – Configuration File Management
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1
Configuration File Management
1-1
Chapter 1 Configuration File Management
1.1 Introduction to Configuration File
A configuration file records and stores user configurations performed to a switch. It also
enables users to check switch configurations easily.
Upon powered on, a switch loads the configuration file known as saved-configuration
file, which resides in the Flash, for initialization. If the Flash contains no configuration
file, the system performs initialization using the default settings. Comparing to
saved-configuration file, the configuration file which is currently adopted by a switch is
known as the current-configuration.
A configuration file conforms to the following conventions:
z The content of a configuration file is a series of commands.
z Only the non-default configuration parameters are saved.
z The commands are grouped into sections by command view. The commands that
are of the same command view are grouped into one section. Sections are
separated by empty lines or comment lines. (A line is a comment line if it starts
with the character “#”.)
z The sections are listed in this order: system configuration section, physical port
configuration section, logical interface configuration section, routing protocol
configuration section, and so on.
z A configuration file ends with a “return”.
1.2 Configuration File-Related Operations
You can perform the following operations on an S3600 Ethernet switch:
z Saving the current configuration to a configuration file
z Removing a configuration file from the Flash
z Checking/Setting the configuration file to be used when the switch starts the next
time
z Setting a configuration file to be the primary/secondary configuration file
Perform the following configuration in user view.
To Next Page
Loading...
Need help?
General