H3C S3600 Series

Operation Manual – Mirroring
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1
Mirroring Configuration
1-8
Operation Command Description
Enter Ethernet port
view of the determined
destination port
interface interface-type
interface-number
—
Define the current port
as the destination port
mirroring-group group-id
monitor-port
Required
LACP and STP must be
disabled on the destination
port
Exit current view
quit
—
Enter Ethernet port
view of the determined
source port
interface interface-type
interface-number
—
Define the current port
as the source port and
specify the direction of
the packets to be
mirrored
mirroring-group group-id
mirroring-port { both |
inbound | outbound }
Required
Display the mirroring
parameter settings
display mirroring-group
{ all | local }
Required
This command can be
executed in any view.
III. Configuring port mirroring in system view
Table 1-8 Configure port mirroring in system view
Operation Command Description
Enter system view
system-view
—
Create a port mirroring
group
mirroring-group group-id
local
Required
Define the determined
destination port
mirroring-group group-id
monitor-port monitor-port
Required
LACP and STP must be
disabled on the
destination port.
Define the determined
source port and
specify the direction of
the packets to be
mirrored
mirroring-group group-id
mirroring-port
mirroring-port-list { both |
inbound | outbound }
Required
Display the mirroring
parameter settings
display mirroring-group { all |
local }
Optional
This command can be
executed in any view.