H3C S3600 Series User Manual

Operation Manual – VLAN-VPN
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1
VLAN-VPN Configuration
1-4
Operation Command Description
Display VLAN VPN
configuration information
about all the ports
display port vlan-vpn
This command can be
executed in any view.
 Note:
After you enable the VLAN-VPN function for a port, you cannot change the port to be a
trunk port or hybrid port, nor can you enable GVRP, GMRP, IRF, NTDP, or STP, 802.1x
and centralized MAC address authentication function for the port.
z Error message appears if you try to change the port to be a trunk port or hybrid port
or enable GVRP, GMRP, IRF, NTDP, STP, 802.1x or centralized MAC address
authentication function for the port by executing corresponding commands.
z If you use the copy configuration command to duplicate the configuration of a port
to a port enabled with the VLAN-VPN function, the configuration concerning port
type (that is, access, trunk, or hybrid), GVRP, GMRP, IRF, NTDP, STP, 802.1x and
centralized MAC address authentication function is not duplicated.
1.3 Inner VLAN Tag Priority Replication Configuration
You can configure to replicate the tag priority of the inner VLAN tag of a VLAN-VPN
packet to the outer VLAN tag to keep the original tag priority after the packet is inserted
an outer VLAN tag.
1.3.1 Configuration Prerequisites
The VLAN-VPN function is enabled.
1.3.2 Configuration Procedure
Table 1-3 Replicate the tag priority of the inner VLAN tag
Operation Command Description
Enter system view
system-view
—
Enter Ethernet port view
interface interface-type
interface-number
—

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English