To Next Page

To Previous Page

Operation Manual – Mirroring

H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1

Mirroring Configuration

1-9

 Note:

z Configurations listed in Table 1-6 do not involve specifying a mirroring group.

Therefore these mirroring settings made in Ethernet port view applies to mirroring

group 1 only.

z Configurations listed in Table 1-7 can be used to add mirroring settings for any

defined mirroring group in Ethernet port view.

z Configurations listed in Table 1-8 are performed in system view. Therefore the

mirroring group ID and port number must be specified.

IV. Configuration Example

Network requirements:

z The source port is GigabitEthernet 1/1/1. All packets received and sent by this port

are to be mirrored.

z The destination port is GigabitEthernet 1/1/4.

Configuration procedure 1:

<H3C> system-view

[H3C] mirroring-group 1 local

[H3C] interface gigabitEthernet 1/1/4

[H3C-GigabitEthernet1/1/4] monitor-port

[H3C-GigabitEthernet1/1/4] quit

[H3C] interface gigabitEthernet 1/1/1

[H3C-GigabitEthernet1/1/1] mirroring-port both

Configuration procedure 2:

<H3C> system-view

[H3C] mirroring-group 1 local

[H3C] interface GigabitEthernet 1/1/4

[H3C-GigabitEthernet1/1/4] mirroring-group 1 monitor-port

[H3C-GigabitEthernet1/1/4] quit

[H3C] interface GigabitEthernet 1/1/1

[H3C-GigabitEthernet1/1/1] mirroring-group 1 mirroring-port both

Configuration procedure 3:

<H3C> system-view

[H3C] mirroring-group 1 local

[H3C] mirroring-group 1 monitor-port GigabitEthernet 1/1/4

[H3C] mirroring-group 1 mirroring-port GigabitEthernet 1/1/1 both

H3C S3600 Series User Manual

Other manuals for H3C S3600 Series