H3C S3600 Series User Manual

Operation Manual – Port Security-Port Binding
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 2
Port Binding Configuration
2-1
Chapter 2 Port Binding Configuration
2.1 Port Binding Overview
2.1.1 Introduction
Port binding enables the network administrator to bind the MAC and IP addresses of a
legal user to a specific port. After the binding, only the user whose device MAC address
is identical with the bound MAC address can use the bound IP address to access the
network through the port. This improves network security and enhances security
monitoring.
2.1.2 Configuring Port Binding
Table 2-1 Configure port binding
Operation Command Description
Enter system view
system-view
—
Bind the MAC address
and IP address of a legal
user to a specific port
am user-bind mac-addr
mac-address ip-addr ip-address
interface interface-type
interface-number
Optional
Enter Ethernet port view
interface interface-type
interface-number
—
Bind the MAC address
and IP address of a legal
user to the current port
am user-bind mac-addr
mac-address ip-addr ip-address
Optional
 Note:
An IP address can be bound with only one MAC address, and vice versa.
2.2 Displaying Port Binding Configuration
After the above configuration, you can use the display command in any view to display
port binding information and verify your configuration.

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English