H3C S3600 Series User Manual

Operation Manual – MAC Address Table
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1 MAC Address Table Management
1-4
z Configuring the maximum number of MAC addresses a port can learn
1.2.1 Configuring a MAC Address Entry
You can add, modify, or remove one MAC address entry, remove all MAC address
entries (unicast MAC addresses only) concerning a specific port, or remove specific
type of MAC address entries (dynamic or static MAC address entries).
You can add a MAC address entry in either system view or Ethernet port view.
I. Adding a MAC address entry in system view
Table 1-2 Add a MAC address entry in system view
Operation Command Description
Enter system view
system-view
—
Add a MAC address entry
mac-address { static | dynamic |
blackhole } mac-address interface
interface-type interface-number
vlan vlan-id
Required
Caution:
z When you add a MAC address entry, the port specified by the interface argument
must belong to the VLAN specified by the vlan argument in the command.
Otherwise, the entry will not be added.
z If the VLAN specified by the vlan argument is a dynamic VLAN, after a static MAC
address is added, it will become a static VLAN.
II. Adding a MAC address entry in Ethernet port view
Table 1-3 Add a MAC address entry in Ethernet port view
Operation Command Description
Enter system view
system-view
—
Enter Ethernet port
view
interface interface-type interface-number
—
Add a MAC
address entry
mac-address { static | dynamic |
blackhole } mac-address vlan vlan-id
Required

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English