H3C S3600 Series User Manual

Operation Manual – Information Center
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1
Information Cente
r
1-17
# syslogd -r &
 Note:
In case of Linux log host, the daemon “syslogd” must be started with the “-r” option.
After all the above operations, the switch can record information in the corresponding
log file.
 Note:
Through combined configuration of the device name (facility), information severity level
threshold (severity), module name (filter) and the file “syslog.conf”, you can sort
information precisely for filtering.
1.4.3 Log Output to the Console
I. Network requirements
The switch sends the following information to the console: the log information of the two
modules ARP and IP, with severity higher than “informational”.
II. Network diagram
console
PC
Switch
console
PC
Switch
console
PC
Switch
console
PC
Switch
console
PC
Switch
console
PC
Switch
console
PC
Switch
console
PC
Switch
Figure 1-3 Network diagram for log output to the console
III. Configuration procedure
# Enable the information center.
<H3C> system-view
[H3C] info-center enable
# Disable the function of outputting information to the console channels.
[H3C] undo info-center source default channel console
# Enable log information output to the console. Permit ARP and IP modules to output
information with severity level higher than informational to the console.

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English