H3C S3600 Series

Operation Manual – Information Center
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1
Information Cente
r
1-11
 Note:
To view debugging information of specific modules, you need to configure the
information type as debug in the info-center source command, and enable
debugging on corresponding modules with the debugging command as well.
1.2.6 Enabling Information Output to the Trap Buffer
Table 1-11 lists the related configurations on the switch.
Table 1-11 Enable information output to the trap buffer
Operation Command Description
Enter system view
system-view
—
Enable the
information center
info-center enable
Optional
By default, the
information center is
enabled.
Enable information
output to the trap
buffer
info-center trapbuffer [channel
{ channel-number |
channel-name } | size
buffersize]*
Optional
By default, the switch
uses information channel
3 to output trap
information to the trap
buffer, which can holds up
to 256 items by default.
Define an
information source
info-center source
{ modu-name | default }
channel { channel-number |
channel-name } [ { log | trap |
debug } { level severity | state
state } ]*
Required
Set the format of
time stamp
info-center timestamp { log |
trap | debugging } { boot | date
| none }
Optional
This is to set the time
stamp format for
log/debugging/trap
information output.
This determines how the
time stamp is presented
to users.