EasyManuals Logo

H3C S3600 Series User Manual

H3C S3600 Series
966 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #794 background imageLoading...
Page #794 background image
Operation Manual – NTP
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1
NTP Configuration
1-9
IV. NTP multicast server mode
When an S3600 Ethernet switch operates in NTP multicast server mode, it multicasts
clock synchronization packets periodically. The devices in the NTP multicast client
mode will respond to these packets and start the clock synchronization process. The
switch operating in this mode can support up to 1,024 multicast clients.
Note:
z The total number of the servers and peers configured for a switch is up to 128.
z After the configuration, an S3600 Ethernet switch does not establish connections
with peers if it operates in NTP server mode. Whereas if it operates in any of the
other modes, it establishes connections with peers.
z If an S3600 Ethernet switch operates in passive peer mode, NTP broadcast client
mode, or NTP multicast client mode, it establishes connections with peers
dynamically. If it operates in any of the other modes, it establishes connections with
peers statically.
1.3 Configuring Access Control Right
The access control right to the NTP server only provides a minimal degree of security
measure. A more secure way is to perform identity authentication.
The right of an access request received by the NTP server is matched from the highest
to the lowest in order of peer, server, synchronization, and query.
Table 1-3 Configure the access control right to the local NTP server
Operation Command Description
Enter system view
system-view
Configure the access
control right to the local
NTP server
ntp-service access
{ peer | server |
synchronization |
query } acl-number
Optional
By default, the access
control right to the local
NTP server is peer.
1.4 Configuring NTP Authentication
In networks with higher security requirements, the NTP authentication function must be
enabled to run NTP. Through password authentication on the client and the server, the
client is synchronized only to the server that passes the authentication. This improves
network security.

Table of Contents

Other manuals for H3C S3600 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the H3C S3600 Series and is the answer not in the manual?

H3C S3600 Series Specifications

General IconGeneral
BrandH3C
ModelS3600 Series
CategorySwitch
LanguageEnglish

Related product manuals