H3C S3600 Series User Manual

Operation Manual – AAA-RADIUS-HWTACACS-EAD
H3C S3600 Series Ethernet Switches-Release 1510
Chapter 1 AAA & RADIUS & HWTACACS
Configuration
1-34
5) If the switch does not receive any response from the CAMS after it has tried the
configured maximum number of times to send the Accounting-On message, it will
not send the Accounting-On message any more.
 Note:
The switch can automatically generate the main attributes (NAS-ID, NAS-IP-address
and session ID) contained in Accounting-On messages. However, you can also
manually configure the NAS-IP-address with the nas-ip command. If you choose to
manually configure the attribute, be sure to configure an appropriate valid IP address. If
this attribute is not configured, the switch will automatically choose the IP address of a
VLAN interface as the NAS-IP-address.
Table 1-23 Enable the user re-authentication at restart function
Operation Command Description
Enter system view
system-view
—
Enter RADIUS scheme
view
radius scheme
radius-scheme-name
—
Enable the user
re-authentication at
restart function
accounting-on
enable [ send times |
interval interval ]
By default, this function is
disabled.
If you use this command
without any parameter, the
system will try at most 15 times
to send an Accounting-On
message at the interval of
three seconds.
1.5 HWTACACS Configuration
1.5.1 Creating a HWTACAS Scheme
The HWTACACS protocol configuration is performed on a scheme basis. Therefore,
you must create a HWTACACS scheme and enter HWTACACS view before performing
other configuration tasks.

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English