H3C S3600 Series User Manual

Operation Manual – Multicast
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 8 MSDP Configuration
8-9
Table 8-2 Configuration tasks
Operation Description Related section
Configure description
information for MSDP
peers
Required
Section 8.3.2 "Configuring
Description Information for MSDP
Peers"
Configure Anycast RP
application
Optional
Section 8.3.3 "Configuring
Anycast RP Application"
Configure an MSDP mesh
group
Optional
Section 8.3.4 "Configuring an
MSDP Mesh Group"
Configure MSDP peer
connection control
Optional
Section 8.3.5 "Configuring MSDP
Peer Connection Control"
8.3.2 Configuring Description Information for MSDP Peers
You can configure description information for each MSDP peer to manage and
memorize the MSDP peers.
Table 8-3 Configure description information for an MSDP peer
Operation Command Description
Enter system view
system-view
—
Enter MSDP view
msdp
—
Configure description
information for an MSDP
peer
peer
peer-address
description text
Optional
The peer-address argument is the
address of the peer. You can
configure addresses of multiple
peers for multiple times.
By default, an MSDP peer has no
description text.
8.3.3 Configuring Anycast RP Application
If you configure the same interface (usually Loopback interface) addresses on two RPs
in the same PIM-SM domain, the two RPs will be MSDP peers to each other. To prevent
failure of RPF check on SA messages between MSDP peers, you must configure the
RP address to be carried in the SA messages.
Table 8-4 Configure Anycast RP application
Operation Command Description
Enter system view
system-view
—
Enter MSDP view
msdp
—

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English