H3C S3600 Series User Manual

Operation Manual – CLI
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1
CLI Configuration
1-3
1.2.2 Configuring a Level for a Specific Command in a Specific View
You can configure a level for a specific command in a specific view. Commands fall into
four levels: visit, monitor, system, and manage, which are identified as 0, 1, 2, and 3
respectively. The administrator can change the command level according to the
requirements..
Table 1-3 lists the operations to configure a level for a specific command.
Table 1-3 Configure a level for a specific command in a specific view
Operation Command Description
Enter system view
system-view
—
Configure a level for a
specific command in a
specific view
command-privilege level
level view view command
Required
It is forbidden to change the
command level at will. Doing
so may bring inconvenience
to maintenance and
operation.
1.2.3 CLI Views
CLI views are designed for different configuration tasks. They are related but
distinguished. You will enter user view once you log in to a switch successfully, where
you can view operation status and statistics information. After executing the
system-view command, you can enter system view, where you can go into other views
by entering corresponding commands.
The following CLI views are provided:
z User view
z System view
z Ethernet interface view
z VLAN view
z VLAN interface view
z Loopback interface view
z Local user view
z User interface view
z FTP client view
z SFTP client view
z MST region view
z Cluster view
z Public key view
z Public key code view
z DHCP address pool view
z PIM view

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English