Operation Manual – FTP and TFTP
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1
FTP and TFTP Configuration
1-6
V. Displaying FTP server information
After the above configurations, you can run the display command in any view to
display the running information of the FTP server and verify your configurations.
Table 1-6 Display FTP server information
Operation Command Description
Display the information about
FTP server configurations on
a switch
display ftp-server
Display the source IP address
set for an FTP server
display ftp-server
source-ip
Display the login FTP client on
an FTP server
display ftp-user
These commands can be
executed in any view.
1.1.3 Configuration Example: A Switch Operating as an FTP Server
I. Network requirements
A switch operates as an FTP server and a remote PC as an FTP client.
z Create a user account on the FTP server with the user name “switch” and
password “hello”.
z Configure the IP address 1.1.1.1 for a VLAN interface on the switch, and 2.2.2.2
for the PC. Ensure the route between the two is reachable.
The switch application named switch.bin is stored on the PC. Upload it to the FTP
server through FTP to upgrade the application of the switch, and download the switch
configuration file named config.cfg from the switch to backup the configuration file.
II. Network diagram
Switch
PC
Network
Network
Switch
PC
Network
Network
Figure 1-2 Network diagram for FTP configurations
III. Configuration procedure
1) Configure the switch
To Next Page
Loading...
Need help?
General