H3C S3600 Series User Manual

Operation Manual – FTP and TFTP
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1
FTP and TFTP Configuration
1-7
# Log into the switch. (You can log into a switch through the Console port or by
Telneting to the switch. See the “Login” module for detailed information.)
<H3C>
# Start the FTP service on the switch and set the user name and the corresponding
password.
<H3C> system-view
[H3C] ftp server enable
[H3C] local-user switch
[H3C-luser-switch] password simple hello
[H3C-luser-switch] service-type ftp
2) Run an FTP client application on the PC to connect to the FTP server. Upload the
application named switch.bin to the root directory of the Flash memory of the FTP
server, and download the configuration file named config.cfg from the FTP server.
The following takes the command line window tool provided by Windows as an
example:
# Enter the command line window and switch to the directory where the file switch.bin is
located. In this example it is in the root directory of C:\.
C:\>
# Access the Ethernet switch through FTP. Input the user name “switch” and password
“hello” to log in and enter FTP view.
C:\> ftp 1.1.1.1
Connected to 1.1.1.1.
220 FTP service ready.
User (1.1.1.1:(none)): switch
331 Password required for switch.
Password:
230 User logged in.
ftp>
# Upload the switch.bin file.
ftp> put switch.bin
200 Port command okay.
150 Opening ASCII mode data connection for switch.bin.
226 Transfer complete.
# Download the config.cfg file.
ftp> get config.cfg
200 Port command okay.
150 Opening ASCII mode data connection for config.cfg.
226 Transfer complete.
ftp: 3980 bytes received in 8.277 seconds 0.48Kbytes/sec.

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English