H3C S3600 Series User Manual

Operation Manual – MSTP
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1
MSTP Configuration
1-23
II. Specify whether the link connected to a port is point-to-point link in
Ethernet port view
Table 1-18 Specify whether the link connected to a port is point-to-point link in Ethernet
port view
Operation Command Description
Enter system view
system-view
—
Enter Ethernet port view
interface interface-type
interface-number
—
Specify whether the link
connected to a port is a
point-to-point link
stp point-to-point
{ force-true | force-false |
auto }
Required
The auto keyword is
adopted by default.
The force-true keyword
specifies that the link
connected to the port is a
point-to-point link.
The force-false keyword
specifies that the link
connected to the port is
not a point-to-point link.
The auto keyword
specifies to automatically
determine whether or not
the link connected to the
port is a point-to-point
link.
 Note:
z Among aggregated ports, you can only configure the links of master ports as
point-to-point links.
z If an auto-negotiating port operates in full duplex mode after negotiation, you can
configure the link of the port as a point-to-point link.
After you configure the link of a port as a point-to-point link, the configuration applies to
all spanning tree instances. If the actual physical link of a port is not a point-to-point link
and you forcibly configure the link as a point-to-point link, temporary loops may be
incurred.
III. Configuration example
# Configure the link connected to Ethernet1/0/1 as a point-to-point link.
1) Perform this configuration in system view.
<H3C> system-view

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English