H3C S3600 Series User Manual

Operation Manual – Login
H3C S3600 Series Ethernet Switches-Release 1510
Chapter 5 Logging in through Web-based Network
Management System
5-1
Chapter 5 Logging in through Web-based Network
Management System
5.1 Introduction
An S3600 Ethernet switch has a Web server built in. You can log into an S3600
Ethernet switch through a Web browser and manage and maintain the switch intuitively
by interacting with the built-in Web server.
To log into an S3600 Ethernet switch through the built-in Web-based network
management system, you need to perform the related configuration on both the switch
and the PC operating as the network management terminal.
Table 5-1 Requirements for logging into a switch through the Web-based network
management system
Item Requirement
The management VLAN of the switch is configured. The
route between the switch and the network management
terminal is available. (Refer to the Management VLAN
Configuration module for more.)
Switch
The user name and password for logging into the
Web-based network management system are configured.
IE is available.
PC operating as the
network management
terminal
The IP address of the management VLAN interface of the
switch is available.
5.2 HTTP Connection Establishment
1) Log into the switch through the Console port and assign an IP address to the
management VLAN interface of the switch See section
3.5.1 "Telneting to a
Switch from a Terminal
" for more.
2) Through the Console port, configure the user name and the password for the
Web-based network management system.
# Configure the user name to be admin.
[H3C] local-user admin
# Set the user level to level 3.
[H3C-luser-admin] service-type telnet level 3
# Set the password to admin.

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English