H3C S3600 Series User Manual

Operation Manual – Login
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 2 Logging in through the Console Port
2-6
2.4 Console Port Login Configuration with Authentication
Mode Being None
2.4.1 Configuration Procedure
Table 2-4 Console port login configuration with the authentication mode being none
Operation Command Description
Enter system view
system-view
—
Enter AUX user interface
view
user-interface aux 0 —
Configure not to
authenticate users
authentication-mode
none
Required
By default, users logging in
through the Console port are
not authenticated.
Set the
baud rate
speed speed-value
Optional
The default baud rate of an
AUX port (also the Console
port) is 9,600 bps.
Set the
check mode
parity { even | none |
odd }
Optional
By default, the check mode of
a Console port is set to none,
that is, no check bit.
Set the stop
bits
stopbits { 1 | 1.5 | 2 }
Optional
The stop bits of a Console port
is 1.
Configure
the
Console
port
Set the data
bits
databits { 7 | 8 }
Optional
The default data bits of a
Console port is 8.
Configure the command
level available to users
logging into the user
interface
user privilege level
level
Optional
By default, commands of level
3 are available to users
logging into the AUX user
interface.
Make terminal services
available
shell
Optional
By default, terminal services
are available in all user
interfaces.
Set the maximum
number of lines the
screen can contain
screen-length
screen-length
Optional
By default, the screen can
contain up to 24 lines.
You can use the
screen-length 0 command to
disable the function to display
information in pages.

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English