H3C S3600 Series User Manual

Operation Manual – Port Basic Configuration
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1 Port Basic Configuration
1-4
 Note:
The access ports or hybrid ports must be added to an existing VLAN.
1.2 Ethernet Port Configuration
1.2.1 Initially Configuring a Port
Table 1-3 Initially configure a port
Operation Command Remarks
Enter system view
system-view
—
Enter Ethernet port view
interface interface-type
interface-number
—
Enable the Ethernet port
undo shutdown
Optional
By default, the port is
enabled.
Use the shutdown
command to disable the
port.
Set the description of the
Ethernet port
description text
Optional
By default, no description
is defined for the port.
Set the duplex mode of
the Ethernet port
duplex { auto | full | half }
Optional
By default, the duplex
mode of the port is auto
(auto-negotiation).
Set the speed of the
Ethernet port
speed { 10 | 100 | 1000 |
auto }
Optional
By default, the speed of
the port is auto
(auto-negotiation).
Set the medium
dependent interface
(MDI) attribute of the
Ethernet port
mdi { across | auto |
normal }
Optional
Be default, the MDI
attribute of the port is
auto.
Allow jumbo frames that
are not larger than 9216
bytes to pass through the
Ethernet port
jumboframe enable
Optional
By default, jumbo frames
that are not larger than
9216 bytes are allowed to
pass through the port.

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English