To Next Page

To Previous Page

Operation Manual – FTP and TFTP

H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1

FTP and TFTP Configuration

1-11

Operation Command Description

Display the fixed source

IP address used by a FTP

client to connect to a FTP

server

display ftp source-ip

This command can be

executed in any view.

 Note:

z The specified interface must be an existing one. Otherwise a prompt appears to

show the configuration fails.

z The value of argument ip-address must be the IP address of the device where the

configuration is performed. Otherwise a prompt appears to show the configuration

fails.

z The source interface/source IP address set for one connection is prior to the fixed

source interface/source IP address set for each connection. That is, for a

connection between an FTP client and an FTP server, if you specify the source

interface/source IP address only used for the connection this time, and the specified

source interface/source IP address is different from the fixed one, the former will be

used for the connection this time.

z Only one fixed source interface or source IP address can be set for the FTP client at

one time. That is, only one of the commands ftp source-interface and ftp

source-ip can be effective at one time. If you execute both of them, the new setting

will overwrite the original one.

1.1.5 Configuration Example: A Switch Operating as an FTP Client

I. Network requirements

A switch operates as an FTP client and a remote PC as an FTP server.

z Create a user account on the FTP server with the user name “switch” and

password “hello”, and authorize the user “switch” with read and write permissions

on the directory named “Switch” on the PC.

z Configure the IP address 1.1.1.1 for a VLAN interface on the switch, and 2.2.2.2

for the PC. Ensure the route between the two is reachable.

The switch application named switch.bin is stored on the PC. Download it to the switch

through FTP to upgrade the switch application, and upload the switch configuration file

named config.cfg to the “switch” directory of the PC to backup the configuration file.

H3C S3600 Series User Manual

Other manuals for H3C S3600 Series