H3C S3600 Series User Manual

Operation Manual – AAA-RADIUS-HWTACACS-EAD
H3C S3600 Series Ethernet Switches-Release 1510
Chapter 1 AAA & RADIUS & HWTACACS
Configuration
1-36
Caution:
z You are not allowed to configure the same IP address for both primary and
secondary authentication servers. If you do this, the system will prompt that the
configuration fails.
z You can remove an authentication server setting only when there is no active TCP
connection that is sending authentication messages to the server.
1.5.3 Configuring HWTACACS Authorization Servers
Table 1-26 Configure TACACS authorization servers
Operation Command Description
Enter system view
system-view
—
Create a HWTACACS
scheme and enter its view
hwtacacs scheme
hwtacacs-scheme-name
Required
By default, no
HWTACACS scheme
exists.
Set the IP address and
port number of the
primary TACACS
authorization server
primary authorization
ip-address [ port ]
Required
By default, the IP address
of the primary
authorization server is
0.0.0.0, and the port
number is 0.
Set the IP address and
port number of the
secondary TACACS
authorization server
secondary authorization
ip-address [ port ]
Required
By default, the IP address
of the secondary
authorization server is
0.0.0.0, and the port
number is 0.
Caution:
z You are not allowed to configure the same IP address for both primary and
secondary authorization servers. If you do this, the system will prompt that the
configuration fails.
z You can remove a server only when it is not used by any active TCP connection for
sending authorization messages.

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English