H3C S3600 Series - 1.3.2 Creating an ISP Domain; 1.3.3 Configuring the Attributes of an ISP Domain

Operation Manual – AAA-RADIUS-HWTACACS-EAD
H3C S3600 Series Ethernet Switches-Release 1510
Chapter 1 AAA & RADIUS & HWTACACS
Configuration
1-14
1.3.2 Creating an ISP Domain
Table 1-5 Create an ISP domain
Operation Command Description
Enter system view
system-view
—
Create an ISP domain
and enter its view, enter
the view of an existing ISP
domain, or set an ISP
domain as the default ISP
domain
domain { isp-name |
default { disable | enable
isp-name } }
Required
If no ISP domain is set as
the default ISP domain,
the ISP domain "system"
is used as the default ISP
domain.
1.3.3 Configuring the Attributes of an ISP Domain
Table 1-6 Configure the attributes of an ISP domain
Operation Command Description
Enter system view
system-view
—
Create an ISP domain
and enter its view, or enter
the view of an existing ISP
domain
domain isp-name
Required
Set the status of the ISP
domain
state { active | block }
Optional
By default, an ISP domain
is in the active state, that
is, all the users in the
domain are allowed to
request network service.
Set the maximum number
of access users that can
be contained in the ISP
domain
access-limit { disable |
enable
max-user-number }
Optional
By default, there is no limit
on the number of access
users that can be
contained in an ISP
domain.
Set the user idle-cut
function
idle-cut { disable |
enable minute flow }
Optional
By default, the user
idle-cut function is
disabled.
Set the
accounting-optional
switch
accounting optional
Optional
By default, the
accounting-optional
switch is closed.