Operation Manual – Login
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 3
Logging in through Telnet
3-17
Figure 3-7 Launch Telnet
5) Enter the password when the Telnet window displays “Login authentication” and
prompts for login password. The CLI prompt (such as <H3C>) appears if the
password is correct. If all VTY user interfaces of the switch are in use, you will fail
to establish the connection and receive the message that says “All user interfaces
are used, please try later!”. A H3C series Ethernet switch can accommodate up to
five Telnet connections at same time.
6) After successfully Telneting to a switch, you can configure the switch or display the
information about the switch by executing corresponding commands. You can
also type ? at any time for help. Refer to the following chapters for the information
about the commands.
Note:
z A Telnet connection is terminated if you delete or modify the IP address of the VLAN
interface in the Telnet session.
z By default, commands of level 0 are available to Telnet users authenticated by
password. Refer to section 1.2 “Command Hierarchy/Command View” in CLI
module for information about command hierarchy.
3.5.2 Telneting to another Switch from the Current Switch
You can Telnet to another switch from the current switch. In this case, the current switch
operates as the client, and the other operates as the server. If the interconnected
Ethernet ports of the two switches are in the same LAN segment, make sure the IP
addresses of the two management VLAN interfaces to which the two Ethernet ports
belong to are of the same network segment, or the route between the two VLAN
interfaces is available.
As shown in
Figure 3-8, after Telneting to a switch (labeled as Telnet client), you can
Telnet to another switch (labeled as Telnet server) by executing the telnet command
and then configure it.
To Next Page
Loading...
Need help?
General