H3C S3600 Series User Manual

Operation Manual – NTP
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1
NTP Configuration
1-7
1.2.2 Configuration Procedure
Table 1-2 Configure NTP implementation modes
Operation Command Description
Enter system view
system-view
—
Configure the switch to
operate in NTP client
mode
ntp-service
unicast-server
{ remote-ip |
server-name }
[ authentication-keyid
key-id | priority |
source-interface
Vlan-interface vlan-id |
version number ]*
Optional
By default, no Ethernet
switch operates in NTP
client mode.
Configure the switch to
operate in NTP peer
mode
ntp-service
unicast-peer { remote-ip |
peer-name }
[ authentication-keyid
key-id | priority |
source-interface
Vlan-interface vlan-id |
version number ]*
Optional
By default, no Ethernet
switch operates in NTP
peer mode.
Enter VLAN interface
view
interface Vlan-interface
vlan-id
—
Configure the switch to
operate in the NTP
broadcast client mode
ntp-service
broadcast-client
Optional
By default, no Ethernet
switch operates in NTP
broadcast client mode.
Configure the switch to
operate in NTP broadcast
server mode
ntp-service
broadcast-server
[ authentication-keyid
key-id | version number ]*
Optional
By default, no Ethernet
switch operates in NTP
broadcast server mode.
Configure the switch to
operate in NTP multicast
client mode
ntp-service
multicast-client
[ ip-address ]
Optional
By default, no Ethernet
switch operates in NTP
multicast client mode.
Configure the switch to
operate in NTP multicast
server mode
ntp-service
multicast-server
[ ip-address ]
[ authentication-keyid
keyid | ttl ttl-number |
version number ]*
Optional
By default, no Ethernet
switch operates in NTP
multicast server mode.

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English