H3C S3600 Series User Manual

Operation Manual – Login
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 2 Logging in through the Console Port
2-9
2.5 Console Port Login Configuration with Authentication
Mode Being Password
2.5.1 Configuration Procedure
Table 2-6 Console port login configuration with the authentication mode being
password
Operation Command Description
Enter system view
system-view
—
Enter AUX user
interface view
user-interface aux 0 —
Configure to
authenticate users
using the local
password
authentication-mode
password
Required
By default, users logging into a
switch through the Console port
are not authenticated; while those
logging in through Modems or
Telnet are authenticated.
Set the local
password
set authentication
password { cipher |
simple } password
Required
Set the
baud
rate
speed speed-value
Optional
The default baud rate of an AUX
port (also the Console port) is
9,600 bps.
Set the
check
mode
parity { even | none |
odd }
Optional
By default, the check mode of a
Console port is set to none, that
is, no check bit.
Set the
stop bits
stopbits { 1 | 1.5 | 2 }
Optional
The default stop bits of a Console
port is 1.
Configure
the
Console
port
Set the
data bits
databits { 7 | 8 }
Optional
The default data bits of a Console
port is 8.
Configure the
command level
available to users
logging into the user
interface
user privilege level
level
Optional
By default, commands of level 3
are available to users logging into
the AUX user interface.
Make terminal
services available to
the user interface
shell
Optional
By default, terminal services are
available in all user interfaces.

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English