H3C S3600 Series - Page 46

Operation Manual – Login
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 2 Logging in through the Console Port
2-10
Operation Command Description
Set the maximum
number of lines the
screen can contain
screen-length
screen-length
Optional
By default, the screen can contain
up to 24 lines.
You can use the screen-length 0
command to disable the function
to display information in pages.
Set history command
buffer size
history-command
max-size value
Optional
The default history command
buffer size is 10. That is, a history
command buffer can store up to
10 commands by default.
Set the timeout time
for the user interface
idle-timeout minutes
[ seconds ]
Optional
The default timeout time of a user
interface is 10 minutes.
With the timeout time being 10
minutes, the connection to a user
interface is terminated if no
operation is performed in the user
interface within 10 minutes.
You can use the idle-timeout 0
command to disable the timeout
function.
Note that if you configure to authenticate the users in the password mode, the
command level available to users logging into a switch depends on both the
authentication-mode password and the user privilege level level command, as
listed in the following table.
Table 2-7 Determine the command level (B)
Scenario
Authentication
mode
User type Command
Command
level
The user privilege level
level command is not
executed
Level 3
Local authentication
(authentication-m
ode password)
Users logging in
through
Console port
The user privilege level
level command is
already executed
Determined
by the level
argument