Operation Manual – AAA-RADIUS-HWTACACS-EAD
H3C S3600 Series Ethernet Switches-Release 1510
Chapter 1 AAA & RADIUS & HWTACACS
Configuration
1-25
1.4.3 Configuring RADIUS Accounting Servers
Table 1-14 Configure RADIUS accounting servers
Operation Command Description
Enter system view
system-view
—
Create a RADIUS
scheme and enter its view
radius scheme
radius-scheme-name
Required
By default, a RADIUS
scheme named "system"
has already been created
in the system.
Set the
accounting-optional
switch
accounting optional
Set the IP address and
port number of the
primary RADIUS
accounting server
primary accounting
ip-address [ port-number ]
You must select one from
the two operations.
By default, the
accounting-optional
switch is closed, that is,
accounting is required.
By default, the IP address
and UDP port number of
the primary accounting
server are 0.0.0.0 and
1813.
Set the IP address and
port number of the
secondary RADIUS
accounting server
secondary accounting
ip-address [ port-number ]
Optional
By default, the IP address
and UDP port number of
the secondary accounting
server are 0.0.0.0 and
1813.
Enable stop-accounting
request buffering
stop-accounting-buffer
enable
Optional
By default,
stop-accounting request
buffering is enabled.
Set the maximum number
of transmission attempts
of a buffered
stop-accounting request.
retry stop-accounting
retry-times
Optional
By default, the system
tries at most 500 times to
transmit a buffered
stop-accounting request.
Set the maximum allowed
number of continuous
real-time accounting
failures
retry
realtime-accounting
retry-times
Optional
By default, the maximum
allowed number of
continuous real-time
accounting failures is five.
If five continuous failures
occur, the switch cuts
down the user
connection.