To Next Page

To Previous Page

Operation Manual – System Maintenance and Debugging

H3C S3600 Series Ethernet Switches-Release 1510 Chapter 4

Device Management

4-5

z Make configuration so that the IP address of a VLAN interface on the switch is

1.1.1.1, the IP address of the PC is 2.2.2.2, and the switch and the PC is reachable

to each other.

The host software switch.bin and the BootROM file boot.btm of the switch are stored in

the directory switch on the PC. Use FTP to download the switch.bin and boot.btm files

from the FTP server to the switch.

II. Network diagram

Switch

NetworkNetwork

SwitchSwitchSwitch

NetworkNetwork

SwitchSwitchSwitch

NetworkNetwork

SwitchSwitchSwitchSwitchSwitch

NetworkNetwork

Figure 4-1 Network diagram of FTP configuration

III. Configuration procedure

1) Configure the following FTP server–related parameters on the PC: an FTP user

with the username as switch and password as hello, who is authorized with the

read-write right on the directory Switch on the PC. The detailed configuration is

omitted here.

2) On the switch, configure a level 3 telnet user with the username as user and

password as hello. Authentication mode is by user name and password.

 Note:

Refer to the part “Login Operation” for configuration commands and steps about telnet

user.

3) Execute the telnet command on the PC to log into the switch. The following

prompt appears:

<H3C>

Caution:

If the Flash memory of the switch is not sufficient, delete the original applications before

downloading the new ones.

4) Initiate an FTP connection with the following command in user view. Enter the

correct user name and password to log into the FTP server.

H3C S3600 Series User Manual

Other manuals for H3C S3600 Series